- Pneumatic Angle Grinder
- Pneumatic Cleaning Gun
- Pneumatic Drill
- Pneumatic Driven Winch
- Pneumatic Grease Gun
- Pneumatic Heavy Duty Rotary Drill
- Pneumatic Hacksaw
- Pneumatic Hand Scaler KC-20
- Pneumatic Impact Wrench 1/2'', 3/4''
- Pneumatic Impact Wrench 1''
- Pneumatic Needle Scaler AMJ-16
- Pneumatic Needle Scaler AMJ-20
- Pneumatic Needle Scaler AMJ-24
- Pneumatic Needle Scaler AMJ-28
- Pneumatic Piston Pump
- Pneumatic Scaling Hammer
- Pneumatic Vacuum Cleaner
Contact Us
Shanghai Allmarine Industry Co.,Ltd.
16-58 Chenbao Road, Malu Industry Park, Jiading Dist., Shanghai City,China.
Tel +86 21-59152099
Fax +86 21-59152055
Fax +86 21-59152055
Email: sales@allmarine.com.cn
Cleaning of the ventilation fans
7/6/2012 7:22:19 PMAfter long-running, filters for dust, dirt blocking the air flow and the effect is best cleaned once a method is as follows: (1) unplug the power every two weeks; (2) twisted ventilation fans loose screws, remove the enclosures; (3) unplug the connector away with the filter and back cover; (4) reconcile with detergent and water to the appropriate concentration; (5) of the filter and after the cover into the container, wash 10 -replaced with clean water after 15 minutes, Do not immerse the motor in the water, do not use water to rinse the small motor; (6) over filter and back cover to re-install back into place. Distance should not be too close to the ventilation fans must be maintained and the humidity balanced.If necessary, can be considered with the use of desiccant dehumidification facilities.To the injection of the cooling device, as far as possible with pure water.The composition of the pure water of high purity, bacteria can reduce the breeding of bacteria in the condensation process. Should always add the water in the sink, to keep it in a safe water level, but also to be replaced regularly.